San Antonio homeowners
How long to run each sprinkler zone in San Antonio
Spray zones and rotor zones need very different minutes. Here is where to start, and how to measure.
Fix your sprinklersOn this page
Why one number does not work
The right run time depends on what is on the zone. Spray heads, the fixed fan-shaped ones, put water down several times faster than rotors, the ones that turn. Running both for the same minutes floods one area and starves the other. Soil, shade and grass type change the answer again.
With watering limited to one day a week under the current SAWS stage, that one watering has to soak in deep. See the SAWS watering rules for your day and hours.
Starting run times for a summer week
These are starting points for an established lawn in full sun in summer. Measure your own zones with the can test below, then adjust.
Spray zones: 20 to 30 minutes in total, split into two or three cycles.
Rotor zones: 40 to 60 minutes in total, split into two cycles.
Multi-stream rotating nozzles: closer to rotor times than to spray times.
Drip zones in beds: 45 to 60 minutes. Drip may run on more days than sprinklers under SAWS rules.
Shaded zones need less, often about half. Slopes need the same total in shorter cycles.
Cycle and soak on San Antonio clay
Much of San Antonio sits on clay or on thin soil over rock. Both take water slowly. So a long single run sends water down the curb, which wastes it and counts as water waste. Split the total into shorter cycles with at least 30 minutes between them so each one soaks in.
Run a zone and time how long it takes for water to start running off.
Set each cycle a little shorter than that.
Add start times until the cycles add up to the total you need.
Leave at least 30 minutes between cycles on the same zone.
Check that the last cycle still ends inside your allowed hours.
Most controllers do this with several start times on one program. Some have a "cycle and soak" setting that does it for you.
Measure it with a can test
Set five or six straight-sided cans, such as tuna cans, around one zone. Run the zone for 15 minutes and measure the water in each can with a ruler. The average tells you how fast that zone waters. Multiply by four for the amount per hour. Most established lawns here do well on about an inch of water in a summer week. This includes rain.
If one can holds far more or less than the others, the problem is coverage, not minutes. A blocked, tilted or mismatched head is the usual cause. See our sprinkler head guide.
Grass type and season
St. Augustine needs the most water of the common lawn grasses here and suffers first in full sun. Bermuda and Zoysia need less and recover after going brown in a dry spell.
Run times should change with the season. Cut them back in spring and fall, and in winter most lawns here need little or no sprinkler water. Many controllers have a "seasonal adjust" or "water budget" setting that changes every zone by a percentage at once.
Run time questions
How long should I run sprinklers in San Antonio?
As a summer starting point, 20 to 30 minutes for spray zones and 40 to 60 minutes for rotor zones, once a week, split into cycles. Then measure and adjust.
Is it better to water longer or more often?
Longer and less often. Deep watering grows deeper roots, and under SAWS rules sprinklers may run only once a week anyway.
Why does water run off before the zone finishes?
The soil cannot take it in that fast. Split the run into shorter cycles with a soak time in between.
Can I water twice in one day?
You can run more than one cycle on your day, inside the allowed hours. That is what cycle and soak is.
Related pages
Start here: All sprinkler guides.
Also useful: Foundation watering in San Antonio. Sprinkler system won't turn on. Backflow preventer leaking.
Need help? Sprinkler repair in San Antonio.
When the minutes are right and the lawn is still dry
Dry patches that do not respond to more minutes point to a fault: low pressure, a clogged nozzle, a leak or heads spaced too far apart. Our guides to leaks and low pressure and zones not working cover the checks. If you would like a licensed irrigator to set it up, SISCO sets the schedule on every repair visit. Repairs start from $150, depending on what your system needs. Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086.
