San Antonio homeowners
Backflow preventer leaking? What to do first
Water spraying from the brass assembly by your house? Shut it off first, then find out which part failed.
Fix your sprinklersOn this page
Stop the water first
The backflow preventer is a brass part, usually beside the house or near the meter. It keeps sprinkler water from flowing back into your drinking water. It sits above ground, which is why it is the part most often damaged in a San Antonio freeze. When it fails, it can spray a lot of water quickly.
Find the isolation valve on the sprinkler supply line, between the meter and the backflow preventer.
Turn it off: a lever handle goes a quarter turn, until it sits across the pipe.
If you cannot find it, shut the water off at the meter or the house shutoff.
Switch the controller to off so no zone tries to run.
Take a photo of the assembly and the leak before anything is moved.
Shutting the isolation valve stops water to the sprinklers only. The water in your house stays on.
Where it is leaking tells you what failed
Water from the top, under the cap or bonnet: on a pressure vacuum breaker, two plastic parts sit under the cap. They are called the bonnet and the poppet. They crack first in a freeze. They can often be replaced with a repair kit without replacing the whole assembly.
A split in the brass body: the body has cracked. The assembly has to be replaced.
Dripping from a handle or a small test port: a ball valve or test cock has been damaged or left partly open. Sometimes it only needs closing; a cracked one needs replacing.
Water from the relief port underneath, on a reduced pressure assembly: a little discharge when the system starts or stops can be normal. A steady stream means dirt on a check valve or a failed part.
Water at a pipe joint below the assembly: the riser or fitting has cracked, not the assembly.
Why freezes break them
Water trapped inside the assembly expands as it freezes. Shutting the water off without draining leaves that water inside, and wet insulation can make it worse. Our winterizing guide explains how to drain and wrap each type before the next freeze.
Repair or replace
A cracked bonnet, a worn seal or a damaged test cock can usually be fixed. The parts are made for each model. A cracked body, a bent stem or an old assembly with no parts available means replacement. The model and size are cast into the brass or printed on a tag. A photo of that helps us bring the right parts.
Do not run the sprinkler system with the backflow preventer removed or bypassed. It protects your household drinking water, and your water utility requires it.
The test afterwards
In Texas, a backflow preventer must be tested when it is put in. The result goes to your water company. Many water companies also want a test after a repair or replacement, and some require one every year. Only a licensed backflow tester can do the test. That is a different license from an irrigator's. SISCO does not test assemblies. We can arrange a backflow inspection with a licensed tester.
Backflow leak questions
Can I still use water in the house if the backflow preventer is leaking?
Yes, once the isolation valve on the sprinkler line is shut. That valve cuts off only the sprinkler system.
Can a leaking backflow preventer be repaired?
Often. A cracked bonnet, poppet or seal can be replaced. A cracked brass body cannot, and the assembly has to be replaced.
Why did my backflow preventer burst?
Almost always a freeze. Water left inside expands and cracks the plastic parts first, then the brass.
Does it need testing after it is fixed?
Texas requires a test when an assembly is installed, and many water companies require one after repair or replacement. Ask your water provider; ours are listed in the water provider guide.
Related pages
Start here: All sprinkler guides.
Also useful: How long to run sprinklers in San Antonio. Foundation watering in San Antonio. Sprinkler system glossary.
Need help? Sprinkler repair in San Antonio.
When to call
Call if the body is cracked, if you cannot find a shutoff, or if the leak comes back after the cap is tightened. SISCO Irrigation repairs sprinkler systems across Greater San Antonio, Boerne and New Braunfels. We have a licensed irrigator on staff, LI 31500. Repairs start from $150, depending on what your system needs. Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086, Monday to Friday, 7:30 a.m. to 4:30 p.m., or see sprinkler repair in San Antonio.
In Cordillera Ranch? The winter visit there is $275. See our winter offer.
