Skip to content

Homeowners

How to winterize your sprinkler system for a San Antonio freeze

Before a freeze: shut off the water to the system, drain the backflow preventer using its maker's steps, wrap it, and turn the controller off.

Fix your sprinklers
On this page

Why San Antonio freezes break sprinkler systems

San Antonio does not get northern winters, which is exactly why freezes here break so many sprinkler systems. Systems are not buried deep, backflow preventers sit above ground, and nobody blows out the lines in October. When a hard freeze comes, the water left in the backflow assembly and the exposed pipe expands and splits brass and PVC. The repairs show up in the first warm week.

Leer en español

Here is what to do before a freeze and what to check after. If any step stops you, call 210-697-9086 and we will talk you through it or come to help you.

Irrigation freeze protection: what freezes first

The backflow preventer is the brass assembly above ground near the meter or the house that stops irrigation water from flowing back into the drinking supply. It holds water under pressure. It is the part that fails most and is hardest to replace.

After that: any exposed PVC riser (the vertical pipe up to a head or valve), the valve box (the green lid in the lawn with the zone valves inside) if it holds water, and the outdoor faucet. Underground lateral lines (the pipes from the valves to the heads) at normal depth usually survive a one-night freeze. They fail in multi-day freezes, when the ground cools.

Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086.

Before a freeze: the quick version

  1. Close the irrigation shutoff (isolation) valve that feeds the backflow preventer. On a ball valve, the handle sits across the pipe when it is closed.

  2. Drain the backflow preventer by the steps in its manufacturer's manual for your exact model (the manual is on the maker's website). Pressure vacuum breakers, double check assemblies and reduced pressure assemblies drain differently, and opening the test cocks alone often does not empty the assembly.

  3. Leave the ball valves and test cocks in the positions that the manual gives. For Watts and FEBCO Series 850 and 860 assemblies, the manual says to leave the ball valves half-open, about 45 degrees (not fully open or fully closed), after draining, because water trapped in a fully open or fully closed ball valve can freeze and crack it.

  4. Wrap the backflow preventer in dry insulation or an insulated cover made for it, with a waterproof outer layer to keep rain out.

  5. Switch the controller to “off” or “rain delay” and leave it plugged in.

  6. Wrap exposed pipe and outdoor faucets in foam sleeves, taped at the joints.

Good to know: the right drain steps depend on the make and model, and the procedure for one type of assembly can damage or fail to protect another. If you are not sure which assembly you have, or the manual is missing, call us at 210-697-9086 or a licensed backflow tester instead of guessing. Don’t use a wrap that stays wet against the brass. Older controllers lose their program without power, and if you have a rain and freeze sensor, check that it works.

Insulation slows freezing but does not stop it in a long freeze, so draining the assembly matters more than wrapping it. For two or more nights below freezing, also have the rest of the system drained as described below.

How cold is too cold for sprinklers?

Protect the system whenever the forecast shows temperatures below 32 degrees Fahrenheit. Water in exposed parts, such as the backflow preventer, risers and a valve box that holds water, can freeze and crack them, and the risk grows with how long it stays cold and with wind. Underground lines at normal depth are usually less exposed, but they are at risk in a freeze that lasts several days. Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086.

For a longer freeze (two nights or more)

Do everything above, then have the rest of the system drained. How that is done depends on how your system was built: some have manual drain valves at the low points, which are opened with the water supply closed, and others are drained by a technician's blow-out. If you do not know which you have, call us at 210-697-9086.

Blowing out lines with a compressor is standard in northern states and rarely needed here. Draining does the job without one. A blow-out is a job for a technician: air pushed back through the backflow preventer destroys it, and too much pressure blows heads apart. If you want one, call us.

How to wrap pipes and the outside faucet

Use foam pipe sleeves from any hardware store, sized to the pipe, with the seam taped. For an outside faucet, use a foam faucet cover or a rag inside a plastic bag, tied. For a backflow preventer, use an insulated bag made for the purpose, or foam sleeves on every pipe section plus a bag over the whole assembly.

Whatever you use, keep it dry under something waterproof. Wet insulation is worse than none. For PVC outdoors, insulation slows the freeze but does not stop it in a multi-day event. So draining matters more than wrapping. Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086.

After the freeze: what to check

  1. Restart the backflow preventer by the spring start-up steps in its manufacturer's manual. For Watts and FEBCO Series 850 and 860 assemblies, the manual says: close all drain valves, test cocks and ball valves; retighten the relief valve cover on reduced pressure units; slowly open the main shutoff valve and then the inlet ball valve; open and close each test cock one at a time to bleed out air; and open the outlet ball valve last, slowly. Other assemblies differ, so use your model's manual.

  2. Check the backflow preventer for any drip, spray or crack in the brass.

  3. Run each zone for a minute and look for bubbling water, heads that don’t rise or weak spray.

  4. Look in the valve box: standing water usually means a cracked valve body.

  5. If the controller lost power, re-enter the program and match it to your watering day.

Good to know: open the valves slowly, because fast opening slams water into the assembly and can crack it. If the backflow preventer leaks, shut the water off again and call 210-697-9086. A cracked body has to be replaced. A cracked cover or check can sometimes be rebuilt with a kit. After a replacement, SAWS requires a licensed backflow tester to test the new assembly and file the report. Underground splits often show as a soggy patch a week later.

Would you like us to do it? See sprinkler winterization in San Antonio.

Do you need to winterize every year?

Most San Antonio winters, you can leave the system on with the controller running a reduced winter schedule, and only do the steps above when a freeze warning is issued. Watch the forecast from late November to early March. Being wrong costs you a backflow preventer. SISCO offers a freeze check before the season and a post-freeze inspection. Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086.

Elsewhere in Texas

Freezes are harder in North Texas and the Panhandle. Some systems there have drain valves at the low points. Others are blown out with air by a technician. Do not try a blow-out yourself. Too much air can wreck the backflow preventer and blow heads apart. On the Gulf Coast, wrap exposed parts when a freeze warning comes. Houston also asks customers to shut sprinklers off from November 1 to February 28. In Greater San Antonio, reach out to the irrigation experts at SISCO Irrigation at 210-697-9086.

Sprinkler freeze questions

At what temperature do sprinkler pipes freeze in Texas?

Water freezes at 32 degrees Fahrenheit, and exposed pipe and backflow preventers can crack when water inside them freezes. Protect the system whenever the forecast is below 32 degrees. How fast damage happens depends on how long it stays cold and on wind, which strips heat from exposed brass. Underground lines at normal depth are usually less exposed but are at risk when it stays below freezing for several days.

Should I turn off my sprinkler system in winter in San Antonio?

Not for the whole winter. Run a reduced schedule and switch the controller off only during freeze warnings. That is because an established lawn still needs a little water from December to February. If you would rather shut the water off at the isolation valve until spring, that is fine as long as you drain the backflow preventer when you do it.

How do I winterize a sprinkler system with a backflow preventer?

Close the shutoff valve that feeds it, drain it using the winterizing steps in the manufacturer's manual for your exact model (the test cocks alone usually do not drain it), leave the ball valves where that manual says, wrap it in dry insulation with a waterproof cover, and switch the controller off. If you are not sure which assembly you have, call SISCO at 210-697-9086 or a licensed backflow tester. Those steps protect the part most likely to fail.

Can a cracked backflow preventer be repaired?

A cracked body cannot; it is replaced. A cracked cover or check assembly can often be rebuilt with a kit. Shut the water off so it stops leaking and call SISCO for the repair. A licensed backflow tester then tests the new assembly and files the report with SAWS.

Will my sprinkler system freeze at 32 degrees? Water starts to freeze at 32 degrees. A short dip to 32 rarely does harm. The risk grows when it stays below freezing for hours, or drops into the 20s. The backflow preventer goes first, since it sits above ground. If a hard freeze is on the way, drain and wrap it. Not sure how? Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086.

Start here: All sprinkler guides.

Also useful: Sprinkler valve problems. Leaks and low pressure. San Antonio sprinkler calendar.

Need help? Sprinkler repair in San Antonio.

All our San Antonio pages are on one page: sprinkler services in San Antonio.

When to call SISCO

If the backflow preventer is leaking, a zone runs weak after a freeze, or water is pooling anywhere it should not be, call 210-697-9086 or see sprinkler repair in San Antonio. We repair freeze damage across Greater San Antonio, Boerne and New Braunfels and set the controller back to your water provider's schedule before we leave.

Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086.

In Cordillera Ranch? The winter visit there is $275. See our winter offer.