Skip to content

Texas homeowners

Sprinkler system glossary: the terms explained

The words irrigators use, in plain English.

Fix your sprinklers
On this page

The parts

Backflow preventer: the brass assembly, usually above ground near the meter, that keeps sprinkler water from flowing back into drinking water.

Leer en español

Isolation valve: the shutoff on the sprinkler line before the backflow preventer. It turns off the sprinklers without turning off the house.

Main line: the pipe from the backflow preventer to the valves. It is under pressure all the time.

Lateral line: the pipe from a valve to its heads. It holds pressure only while the zone runs.

Valve: the device that opens and closes a zone. It sits in a valve box in the ground.

Valve box: the green or black lid in the lawn with a valve underneath.

Manifold: a group of valves plumbed together in one box.

Solenoid: the cylinder with two wires on top of a valve. Power from the controller makes it open the valve.

Diaphragm: the rubber disc inside a valve that seals it shut.

Controller: the timer that runs the system. Also called a timer or clock.

Station: a numbered terminal on the controller, one for each zone.

Common wire: the one wire, usually white, shared by every valve.

Rain sensor: a device that stops watering when it rains.

The heads

Spray head: a pop-up head that sprays a fixed fan of water, for small areas.

Rotor: a head that turns a single stream, for larger areas.

Nozzle: the part the water comes out of. It sets the pattern and the amount.

Riser: the part of a head that pops up, or the short pipe under a head.

Arc: the slice of a circle a head covers.

Radius: how far a head throws.

Check valve head: a head with a built-in valve that stops water draining out at low points.

Drip irrigation: tubing with emitters that drip water at the base of plants.

The terms

Zone: a group of heads run by one valve.

Precipitation rate: how fast a head puts down water, in inches per hour.

Matched precipitation: every head on a zone watering at the same rate.

Hydrozoning: putting plants with similar water needs on the same zone.

Cycle and soak: splitting a run time into shorter runs so water soaks in.

Static pressure: water pressure with nothing running.

Low-head drainage: water draining from the lowest head after a zone shuts off.

Water hammer: a bang in the pipes when a valve shuts too fast.

Overspray: water landing on pavement, walls or fences.

As-built: the final drawing of a system as it was actually installed.

Drought stage: a level of watering restriction declared by a water utility.

TCEQ: the Texas Commission on Environmental Quality, which licenses irrigators.

Licensed irrigator: a person licensed by TCEQ to design, install and repair irrigation systems.

Glossary questions

What is a backflow preventer?

A brass assembly that keeps sprinkler water from flowing back into your drinking water.

What is a sprinkler zone?

A group of heads run by one valve.

What is a solenoid on a sprinkler valve?

The cylinder with two wires that opens the valve when the controller sends power.

What does precipitation rate mean?

How fast a sprinkler head puts down water, in inches per hour.

Start here: All sprinkler guides.

Also useful: Backflow preventer leaking. How long to run sprinklers in San Antonio. Fall sprinkler checklist.

Need help? Sprinkler repair in San Antonio.

Need a hand?

SISCO repairs sprinklers across Greater San Antonio, Boerne and New Braunfels. Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086 or see sprinkler repair.