Texas homeowners
Orbit sprinkler head or valve leaking? How to fix it
A head leaking at the base needs a new seal or head. A valve that won't shut needs its diaphragm cleaned.
Fix your sprinklersOn this page
Where is it leaking?
Orbit heads and valves are sold in most hardware stores. So they are on a lot of Texas lawns. They leak for the same reasons as any brand. Start by working out where the water comes from and when: while the zone runs, or after it shuts off.
Orbit head leaking at the base while the zone runs
Water pooling around the head means the riser seal has worn or the body has cracked, often from a mower or a tire. Unscrew the cap, pull the riser assembly, and look at the seal. A worn seal on an old head is not worth chasing: replace the head. Use the same brand, or re-head the whole zone to one brand, because the internal parts do not interchange.
Orbit head leaking after the zone shuts off
Water seeping from the lowest head after each run is the pipe draining downhill, not a broken head. A check-valve head at the low point holds the water in the pipe. If water runs constantly from a head with the system off, the zone valve is not closing.
Orbit valve leaking or not shutting off
Close the isolation valve to stop the water.
Check the solenoid is screwed down snug and the bleed screw is closed.
Unscrew the valve top and lift out the diaphragm.
Rinse the diaphragm and the seat, and look for tears or grit.
Reassemble, open the water slowly, and run the zone.
A torn diaphragm needs a replacement of the same model. A cracked valve body, often after a freeze, means a new valve.
Orbit anti-siphon valve leaking from the top
A brief spit of water when the zone starts is normal. Constant leaking from under the cap while the zone runs means the vent seal is worn. Orbit sells rebuild kits for it. The valve must sit at least 6 inches higher than the highest head on its zone.
Which parts interchange
Spray nozzles from Orbit, Hunter and Rain Bird thread onto each other's spray bodies. So a nozzle swap is easy. The internal risers and seals do not interchange, and neither do valve diaphragms or solenoids across brands. When in doubt, take the old part to the store.
Orbit leak questions
Why is my Orbit sprinkler head leaking?
A worn riser seal or a cracked body if it leaks while running. Low-head drainage or a valve that won't close if it leaks afterward.
Why won't my Orbit valve shut off?
Usually grit under the diaphragm or a torn diaphragm. Clean or replace it.
Can I put a Rain Bird nozzle on an Orbit head?
Yes, on spray heads. Nozzles interchange; internal parts do not.
Should I replace Orbit heads with another brand?
You can. Keep one brand and matched nozzles per zone so the zone waters evenly.
Related pages
Start here: All sprinkler guides.
Also useful: Sprinkler head broke off. When to turn sprinklers off and on in Texas. How to program a sprinkler controller.
Need help? Sprinkler repair in San Antonio.
Need a hand?
SISCO repairs heads and valves across Greater San Antonio, Boerne and New Braunfels. Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086 or see our sprinkler head guide and valve guide.
