Skip to content

Texas homeowners

Sprinkler head broke off? What to do right now

Turn the system off, replace the head or the riser under it, and flush the line before fitting the nozzle.

Fix your sprinklers
On this page

First, stop the water

A broken head shoots a geyser when its zone runs, wastes a lot of water and leaves the rest of the zone weak. Switch the controller to "off" so the zone does not run again. If water flows with the system off, close the isolation valve, the handle on the pipe before the backflow preventer.

Leer en español

What broke: the head or the riser?

Dig a few inches around the head and look. If the top is snapped or the body is cracked, the head needs replacing. If the head is intact but leaning or loose, the riser underneath, the short threaded pipe that connects it to the line, has snapped. That is common after a mower or a car wheel hits the head.

How to replace a broken head

  1. Dig out the soil around the head down to the fitting.

  2. Unscrew the head counterclockwise, keeping dirt out of the open pipe.

  3. If the riser snapped, remove the broken piece from the fitting and fit a new riser.

  4. Run the zone for a few seconds to flush dirt out of the line.

  5. Screw on a new head of the same type and height, then fit the nozzle.

  6. Run the zone, aim the head and refill the soil.

Match the new head to the old one: same type, the same pop-up height and the same nozzle size, so the zone still waters evenly.

If the pipe fitting is cracked

If the fitting in the ground is cracked, the repair means cutting and gluing pipe. See our leak guide for how, and call 811 before digging more than a few inches.

Stop it happening again

Heads at driveway corners get driven over. Move them a few inches back, or fit them on a flexible swing joint that gives instead of snapping.

Heads that sit high get hit by mowers. Set the top level with the soil.

Heads along sidewalks get kicked and stepped on. A flexible connection underneath helps here too.

Broken head questions

What do I do if a sprinkler head breaks off?

Turn the system off, dig around the head, and replace the head or the riser beneath it. Flush the line before fitting the nozzle.

Can I run my sprinklers with a broken head?

It wastes water, weakens the zone and can break your water company's water waste rules. Fix it first.

How do I get a broken riser out of the fitting?

A riser extractor tool from a hardware store grips the inside and unscrews it.

Why does the same head keep breaking?

It is in the path of a mower or a wheel. Move it, lower it, or fit a flexible swing joint.

Start here: All sprinkler guides.

Also useful: When to turn sprinklers off and on in Texas. Rain Bird vs Hunter vs Orbit sprinkler heads. Orbit sprinkler head or valve leaking.

Need help? Sprinkler repair in San Antonio.

Need a hand?

SISCO replaces broken heads across Greater San Antonio, Boerne and New Braunfels. Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086 or see sprinkler repair.