Skip to content

Texas homeowners

Texas sprinkler system rules in plain English

One set of state rules covers every Texas sprinkler system. Your city can add more.

Fix your sprinklers
On this page

Where the rules come from

Texas regulates landscape irrigation statewide through the Texas Commission on Environmental Quality (TCEQ), in Chapter 344 of Title 30 of the Texas Administrative Code. These rules apply in every city. Your city or water utility can add its own on top: permits, plan review, inspections and watering days.

Leer en español

Who must be licensed

Anyone who installs, repairs or services irrigation systems for others must be a licensed irrigator or an irrigation technician working under one. A technician may not act as an irrigator or advertise irrigation services. Homeowners are exempt for their own home. But their work must still meet the state's standards.

What every new system needs

An irrigation plan: a scaled drawing, sealed, signed and dated by the licensed irrigator, kept on site during installation with changes marked in red.

Backflow protection wherever the system connects to drinking water, tested when it is installed.

An isolation valve between the water meter and the backflow device.

A rain or moisture shut-off device on systems with an automatic controller, except in 14 Far West Texas counties.

A licensed irrigator or technician on site during installation.

How a system must be designed

Zones are separated by plant type, sun, slope and soil. Every head in a zone waters at the same rate. Water must not be sprayed over hard surfaces, and pop-up and rotor heads sit at least 4 inches from hardscape. Above-ground spray is not allowed in strips narrower than 48 inches with traffic on two or more sides.

Rules that reach existing systems

Replacing a controller triggers the rain or moisture sensor rule.

Repairs that dig at the meter or the backflow device require an isolation valve to be added if there is none.

Repairs and added zones do not need a new irrigation plan.

How to use these rules as a homeowner

  1. Ask any irrigator for a TCEQ license number and check it in TCEQ's public search.

  2. On a new system, ask to see the sealed irrigation plan.

  3. Check the system has a backflow preventer, an isolation valve and a rain sensor.

  4. Keep the plan and the final drawing; they make every later repair easier.

What your city adds

San Antonio's SAWS reviews plans and inspects new systems. Dallas requires a sprinkler permit and rain and freeze sensors. Austin inspects new residential systems. Cities of 20,000 people or more must check that the irrigator who designs and installs a system is licensed. See our irrigation plans page for San Antonio.

Texas rule questions

Who regulates sprinkler systems in Texas?

TCEQ, under Chapter 344 of Title 30 of the Texas Administrative Code. Cities and water companies add local rules.

Can a homeowner install their own sprinkler system in Texas?

Yes, at their own home, without a license. The work must still meet the state's standards.

Is a rain sensor required in Texas?

On new automatic systems and replacement controllers, outside 14 Far West Texas counties.

Does every new system need an irrigation plan?

Yes. A licensed irrigator seals it, and it stays on site during installation.

Start here: Irrigation plans in San Antonio.

Also useful: Irrigation plans for landscape architects. Irrigation plans for irrigation contractors. Irrigation plans in Texas.

About this page

A plain-English summary by SISCO Irrigation, licensed irrigator LI 31500. Source: TCEQ's rules and its questions and answers for irrigators, checked November 12, 2026. In Greater San Antonio, reach out to the irrigation experts at SISCO Irrigation at 210-697-9086.