Skip to content

Texas homeowners

Rain sensor not working? How to test and fix it

Two failures: sprinklers run in the rain, or nothing runs at all. The bypass switch tells you which.

Fix your sprinklers
On this page

A rain sensor fails in one of two ways

Either it never trips, and your sprinklers run in the rain, or it trips and stays tripped, and nothing runs at all. The second is one of the most common reasons a whole system seems dead.

Leer en español

Start with the bypass switch

Most controllers have a switch marked "sensor" with two positions: active and bypass.

  1. If no zone will run, set the switch to bypass and try a zone.

  2. Runs now? The sensor is holding the system off.

  3. If sprinklers run in the rain, check the switch is on active, not bypass.

  4. Test the sensor by its manual, for example by pressing its test spindle while a zone runs.

If the sensor holds the system off

It is still wet: sensors with absorbent disks take a day or more to dry out after rain. That is normal.

The disks are worn out: old disks stay swollen. Replace the disks or the sensor.

A broken wire: on most wired sensors, a cut wire looks the same as rain to the controller.

A dead battery: on wireless sensors, a dead battery or a lost signal stops the system.

If sprinklers run in the rain

The switch is on bypass: someone bypassed it and forgot.

The sensor is sheltered: under eaves, a tree or a gutter overhang, so rain does not reach it.

The setting is too high: many sensors let you set how much rain trips them.

It is not connected: the wires were never attached to the sensor terminals.

Testing by model

On many wired sensors, start a zone with a manual program start, then press and hold the spindle on top: the zone should stop. On some wireless models you wet the disks or press the stem, and the sensor can take up to 45 seconds to respond. The sensor's own manual is the authority.

The rules

Texas requires a rain or moisture shut-off device on new automatic systems and whenever a controller is replaced, outside 14 Far West Texas counties. Dallas requires rain and freeze sensors on automatic systems, and Fort Worth on systems installed since June 1, 2007. Watering in the rain is also treated as water waste by many water companies.

Questions

Why are my sprinklers running in the rain?

The sensor is bypassed, sheltered from rain, set too high, or has failed.

Why won't my sprinklers run after it rained?

The sensor is still wet or stuck. Set the switch to bypass to confirm.

How long does a rain sensor last?

The disks wear over several years. Replace them or the sensor when it stops responding properly.

Can I leave the sensor on bypass?

Only for testing. Bypassed, the system waters in the rain.

Start here: All sprinkler guides.

Also useful: How to replace a sprinkler solenoid. Repair or replace a sprinkler system. Sprinkler wiring problems.

Need help? Sprinkler repair in San Antonio.

Need a hand?

SISCO repairs sensors and controllers across Greater San Antonio, Boerne and New Braunfels. Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086 or see our controller guide.