Skip to content

Texas homeowners

How to replace a sprinkler valve solenoid

No click at the valve and a bad reading on the meter? The solenoid unscrews by hand and a new one goes on in minutes.

Fix your sprinklers

What the solenoid does

The solenoid is the small cylinder with two wires on top of each zone valve. When the controller sends power, it lifts a plunger and the valve opens. When it fails, the zone will not start, or sometimes will not stop.

Leer en español

Is it really the solenoid?

Run the zone from the controller and listen at the valve. A click means the solenoid has power and is working, and the fault is in the valve itself. No click means the solenoid or the wire to it. With a multimeter set to ohms across the solenoid's two wires, roughly 20 to 60 ohms is healthy. Zero is a short and no reading is an open coil. Either means a new solenoid.

What you need

A new solenoid for the same brand of valve, two waterproof wire connectors, and wire strippers. Solenoids are not interchangeable between brands.

How to replace it

  1. Turn the controller off and close the isolation valve.

  2. Cut the two wires to the old solenoid, close to its connectors.

  3. Unscrew the old solenoid counterclockwise by hand; expect a little water.

  4. Check the small plunger and seat are clean, then screw the new solenoid on hand tight.

  5. Strip the wires and join them with waterproof connectors. Either solenoid wire can go to either field wire.

  6. Open the water slowly and run the zone.

Do not overtighten: hand tight is enough, and a wrench can crack the plastic.

If the zone still does not work

Check the wire from the controller, and the diaphragm inside the valve. A solenoid that clicks on a valve that still will not open usually means a flow control screwed down or a clogged port. See our leaking sprinkler valve guide.

Questions

How do I know if a sprinkler solenoid is bad?

No click at the valve when the zone runs, and a multimeter reading outside roughly 20 to 60 ohms.

Can I replace a solenoid without replacing the valve?

Yes. It unscrews from the top of the valve.

Are sprinkler solenoids universal?

No. Match the solenoid to the valve's brand.

Does it matter which wire goes where?

No. Either solenoid wire can connect to the common or the zone wire.

Related pages

Start here: All sprinkler guides.

Also useful: Repair or replace a sprinkler system. New homeowner's guide to a sprinkler system. Rain sensor not working.

Need help? Sprinkler repair in San Antonio.

Need a hand?

SISCO repairs valves and solenoids across Greater San Antonio, Boerne and New Braunfels. Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086 or see sprinkler repair.