Skip to content

Texas builders

Texas irrigation plan requirements: a checklist

Every new Texas irrigation system needs a sealed plan. Here is what it has to show.

Discuss a plan
On this page

Texas requires a plan for every new irrigation system

Under Texas rules, an irrigation plan is required for every new landscape irrigation system. It is a scaled drawing of the system to be installed, and the licensed irrigator must seal, sign and date it. Repairs, maintenance and added zones on an existing system do not need a new plan.

Leer en español

What the plan must show

General information: the irrigator's seal, the signature below the seal, the date sealed, a north arrow, a legend and a scale.

The site: physical features and the boundaries of the areas to be watered.

The water: the water source, the backflow prevention device and the design pressure.

The system: the zones and their flow, the controller, the sensors, the valves, pressure regulation, the main line and lateral lines, and the heads or drip.

The design rules the plan must follow

Zones separated by plant type, sun and shade, slope and soil. Every head in a zone watering at the same rate. No spray over hard surfaces, with pop-up and rotor heads at least 4 inches from hardscape. No above-ground spray in strips narrower than 48 inches with traffic on two or more sides. An isolation valve between the meter and the backflow device, and a rain or moisture shut-off device on automatic systems outside 14 Far West Texas counties.

During and after installation

  1. Keep the sealed plan on site during installation.

  2. Mark any changes on the plan in red.

  3. Have a licensed irrigator or technician on site while the system is installed.

  4. Test the backflow device before the system goes into service.

  5. Produce the final as-built plan when the work is complete, and give it to the owner.

What your city adds

The state rules do not require a city to review the plan. But many do. SAWS reviews every plan in its service area and inspects the installed system. See our SAWS plan checklist details. Dallas requires a sprinkler permit, and Austin inspects new residential systems. Ask your city's development services or your water utility before work starts.

Plan requirement questions

What must a Texas irrigation plan include?

The irrigator's seal, signature and date, a north arrow, legend and scale, the site, the water source and backflow device, and the full system layout.

Does the plan have to be on site?

Yes, during installation, with changes marked in red.

Is a plan needed to add a zone?

No. Texas requires a plan for new systems, not for repairs or added zones.

Who gets the final plan?

The owner gets the final as-built plan when the installation is complete.

Start here: Irrigation plans in San Antonio.

Also useful: Sprinkler system permit in San Antonio. Irrigation plans for Dallas. SAWS irrigation plan checklist.

About this page

A summary by SISCO Irrigation, licensed irrigator LI 31500, checked November 12, 2026 against TCEQ's rules. Need a sealed plan for a project anywhere in Texas? Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086.