Texas homeowners
How a Texas sprinkler system works, and how to care for it
From the meter to the lawn: the parts, the Texas rules and a year of care.
Fix your sprinklersOn this page
How a Texas sprinkler system works
A sprinkler system is a set of parts that take water from your meter, protect the drinking water it came from, and deliver it zone by zone on a schedule. Knowing the parts makes every problem easier to find, and in Texas several of them are required by state rules.
The parts, from the meter to the lawn
Isolation valve: a shutoff between the meter and the backflow preventer, so you can turn off the sprinkler water alone. Texas requires one on new systems.
Backflow preventer: the brass assembly, usually above ground, that keeps sprinkler water from flowing back into your drinking water. Texas requires backflow protection on every system connected to drinking water.
Main line: the pipe from the backflow preventer to the valves, under pressure all the time.
Valves: one per zone, in green boxes in the lawn, opened by the controller.
Lateral lines: the pipes from each valve to its heads, under pressure only while the zone runs.
Heads and drip: spray heads for small areas, rotors for large ones, and drip for beds.
Controller: the timer that opens each valve on schedule.
Rain or moisture sensor: stops watering in rain. Texas requires one on new automatic systems and with a replacement controller, outside 14 Far West Texas counties.
A year of care in Texas
Spring: turn the water back on slowly, run each zone, fix broken heads and set the controller to your water company's schedule.
Summer: about an inch of water a week including rain, cycle and soak on clay, and watch for dry spots and runoff.
Fall: cut run times as temperatures drop, and book any free check your water company offers.
Winter: reduce watering or switch off, and protect the backflow preventer before a freeze.
Texas rules every system owner should know
Watering days and hours are set by your water utility, not the state. They change with drought stages. Anyone you pay to install or repair a system must be a TCEQ-licensed irrigator or work under one. New systems need a sealed irrigation plan, a rain sensor, backflow protection and an isolation valve, with spray kept off pavement and heads matched within each zone. Many water companies also require the backflow preventer to be tested by a licensed tester on a set schedule.
Signs your system needs attention
A water bill that jumped, a soggy patch that never dries, water running with the system off, heads that don't pop up, a zone that won't run or won't stop, or brown spots in a green lawn. Each points to a different part, and the meter test is the first step for any of them.
In the San Antonio area
SISCO repairs and maintains sprinkler systems across Greater San Antonio, Boerne and New Braunfels, with a licensed irrigator on staff. Call 210-697-9086 or see sprinkler repair.
Sprinkler system questions
What parts does a sprinkler system have?
An isolation valve, a backflow preventer, the main line, zone valves, lateral lines, heads or drip, a controller and a rain sensor.
What is required on a new sprinkler system in Texas?
A sealed irrigation plan, backflow protection, an isolation valve, a rain or moisture sensor, matched heads within each zone, and no spray on hard surfaces.
How often should a sprinkler system be checked?
At least each spring, and after any freeze. Many water companies offer a free check.
Who sets my watering days in Texas?
Your water utility. Your water bill names it.
Related pages
Start here: All sprinkler guides.
Also useful: How to adjust sprinkler heads. How to find buried sprinkler heads. Drip and smart controllers for Texas yards.
Need help? Sprinkler repair in San Antonio.
Sources
Checked November 12, 2026: TCEQ's questions and answers for irrigators and 30 Texas Administrative Code Chapter 344. Texas A&M AgriLife watering guidance.
Have a sprinkler question? Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086.
