Skip to content

Texas homeowners

Rain sensors in Texas: the law and how to test yours

Replacing your controller? Texas requires a rain or moisture sensor with it.

Fix your sprinklers
On this page

What a rain sensor does

A rain sensor is a small device, wired or wireless, that tells your sprinkler controller to skip a cycle when it rains or the ground is already wet. It mounts where rain falls on it, usually on a gutter edge or a fence post. It stops the one kind of watering that is pure waste: running sprinklers in the rain.

Leer en español

What Texas requires

Texas requires a rain or moisture shut-off device, or other technology that stops the system during rain, on every new automatically controlled irrigation system. The same rule applies when the controller on an existing system is replaced: the replacement must include one. Homeowners installing their own system must meet it too.

Fourteen Far West Texas counties are excluded: El Paso, Hudspeth, Culberson, Jeff Davis, Presidio, Brewster, Terrell, Loving, Winkler, Ward, Reeves, Ector, Crane and Pecos.

Replacing a valve or a head does not trigger the rule. Replacing the controller does. Your city can add its own rules: Dallas requires rain and freeze sensors on automatic systems, and Fort Worth on systems installed since June 1, 2007.

How to test your rain sensor

The right test depends on the make and model. So the sensor's own manual is the authority. Two common examples:

Hunter Mini-Clik (wired): start a zone using the controller's Manual All Stations or Manual Program start (a single-station manual start ignores the sensor), then press and hold the spindle on top of the sensor until it clicks. The zone should stop.

Rain Bird WR2 (wireless): wet the disks under the sensor cap, or gently press the stem in the center of the cap with a pencil eraser. Rain Bird says the sensor can take up to 45 seconds to trip.

Any other model: follow its manual. Some sensors trip instantly and some slowly, and pressing the wrong part can damage the device. If the test fails, check the sensor bypass switch at the controller, then the battery on a wireless model.

When to call

If you are replacing a controller, the sensor is part of the job under Texas rules, not an optional extra. SISCO repairs sprinkler systems and controllers across Greater San Antonio, Boerne and New Braunfels. In the area? Call 210-697-9086 or see sprinkler repair.

Rain sensor questions

Is a rain sensor required in Texas?

On new automatic systems, yes, everywhere except 14 Far West Texas counties. On an existing system, it becomes required when the controller is replaced.

My system is old and has no sensor. Do I have to add one?

The statewide rule applies when the controller is replaced. But your city or water utility can require one sooner. So check its page. Adding one now still cuts waste.

Does a smart controller count as a rain sensor?

The rule allows "other technology" that stops watering during rain. But TCEQ has not said whether a smart controller's weather feature alone qualifies. A physical rain or moisture sensor is the sure answer.

Where should the sensor go?

In open air where rain falls on it: not under eaves, not in the spray of a head, and within signal range of a wireless receiver.

Start here: All sprinkler guides.

Also useful: How much to water a Texas lawn. Sprinkler valve problems in Texas. Backflow prevention in Texas.

Need help? Sprinkler repair in San Antonio.

Sources

Checked November 12, 2026: 30 Texas Administrative Code §344.62 and TCEQ's questions and answers for irrigators (tceq.texas.gov). Hunter Mini-Clik and Rain Bird WR2 test instructions. SaveDallasWater.com. City of Fort Worth.

Have a sprinkler question? Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086.