Skip to content

Homeowners with Hunter valves

Hunter PGV valve problems: the maker's checklist

Hunter lists five reasons a valve will not close. Grit is number one.

Fix your sprinklers

Start with what the valve is doing

The Hunter PGV is a common home sprinkler valve. Hunter's support pages list the causes for each kind of trouble. Here they are in plain words. They cover Hunter valves in general.

Leer en español

It will not close

Hunter lists five causes, in this order.

Grit. This is the most common one. Dirt gets caught under the rubber diaphragm.

A torn diaphragm.

The solenoid was opened by hand. Turn it to the right until it is snug.

The bleed screw is loose. Tighten it by hand.

The valve is in backward. The arrow on the body must point to the sprinkler heads.

Hunter valves also need at least 20 psi of water pressure to close.

How to clean it

  1. Turn the water off at the backflow device.

  2. Unscrew the solenoid. Check that its plunger moves freely.

  3. Take out the lid screws and lift the lid.

  4. Lift out the diaphragm and spring. Note which way up it sits.

  5. Rinse it all, clear the body and put it back.

Look at the diaphragm for tears. Look at the seat in the body for nicks. A torn diaphragm or a scratched seat will not seal.

It closes, but slowly

Most valves close 10 to 20 seconds after the zone ends. If yours takes far longer, tiny ports in the diaphragm are clogged. Hunter's fix is a new diaphragm assembly.

It will not open

The water is off. Check the supply. Turn the solenoid a quarter to half turn to the left to test by hand.

Low voltage. The timer should send 24 to 28 volts to the valve. A bad wire or a bad solenoid stops it.

Clogged ports. If the valve opens with the bleed screw but not with the solenoid, a port inside is blocked.

It leaks at the body

A crack in the body means a new valve. Loose lid screws, an open bleed screw or a loose solenoid just need to be snugged.

When to call

Call if cleaning did not fix it, or the valve is cracked. Repairs start from $150, depending on what your system needs. More in our valve guide.

Questions

Why won't my Hunter valve close?

Most often grit under the diaphragm. A torn diaphragm, a loose solenoid or an open bleed screw can also do it.

How long should a sprinkler valve take to close?

Most close within 10 to 20 seconds after the zone ends.

How do I open a Hunter valve by hand?

Turn the solenoid a quarter to half turn to the left. Turn it right until snug to close.

Why won't my Hunter valve open?

The water is off, the valve is not getting enough voltage or a port inside is clogged.

Related pages

Start here: Sprinkler parts and models.

Also useful: Rain Bird DV valve. Hunter MP Rotator. Rain Bird 5000 rotor.

Need help? Sprinkler repair in San Antonio.

Need a hand?

Valve still stuck? Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086.