Skip to content

Homeowners with Hunter MP Rotator nozzles

Hunter MP Rotator: adjust the arc and the distance

MP Rotators send out slow, turning streams. They adjust by hand, while the water is on.

Fix your sprinklers

What an MP Rotator is

An MP Rotator is a nozzle that fits on a pop-up spray body. It does not make a fan of mist. It sends out thin streams that turn slowly. It puts water down much slower than a normal spray. That means less runoff on slopes and clay.

Leer en español

Adjust it in five steps

  1. Find the flat side of the nozzle. That marks the left edge.

  2. Twist the pop-up stem so the flat side points at the left edge of the area.

  3. Turn the zone on, so the nozzle is up and turning.

  4. Turn the ring to the right to widen the arc. Turn it left to narrow it.

  5. Turn the center screw to the right to shorten the throw.

You can turn the ring by hand or with Hunter's small tool. The center screw takes a small flat screwdriver.

How far can you cut the distance?

By up to 25 percent. That takes about four full turns to the right. Unlike a normal spray nozzle, the screw does not shut the water off all the way.

Need it shorter still? Then it is the wrong size nozzle, or the pressure is too high.

Pressure matters

Hunter says the MP Rotator works best at 40 psi. Steady pressure over 55 psi wears the nozzle out and makes it spin too fast. If yours mist or whirl, the zone needs pressure control at the heads.

It stopped turning

Hunter gives two causes.

Grit. Unscrew the nozzle and rinse the small filter screen under it. Put it back. Turn the zone on. Open the arc and the distance all the way, then work the arc open and closed a few times.

Low pressure. Too little pressure makes it turn slowly or not at all. A leak on the zone, or too many heads, can cause it.

Run them longer

MP Rotators put water down slowly. A zone needs to run two to three times as long as a zone of normal sprays. Do not mix the two on one zone. One part of the yard will flood before the other is wet.

Questions

How do I adjust the arc on an MP Rotator?

With the water on, turn the ring to the right to widen the arc and to the left to narrow it.

Why is my MP Rotator not turning?

Grit in the filter screen, or low water pressure.

How long should MP Rotators run?

Two to three times as long as normal spray heads, since they put water down more slowly.

Can I mix MP Rotators and normal sprays on one zone?

No. They water at different rates, so one area gets too much and the other too little.

Related pages

Start here: Sprinkler parts and models.

Also useful: Rain Bird 5000 rotor. Hunter PGP rotor. Hunter PGV valve.

Need help? Sprinkler repair in San Antonio.

Need a hand?

Want the zone set right? Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086.