Skip to content

Texas homeowners

Drip irrigation maintenance: a seasonal checklist

Clean the filter, flush the lines and walk the bed while the zone runs.

Fix your sprinklers
On this page

Drip fails quietly

A broken spray head shoots a geyser you cannot miss. A drip zone fails without a sign: a clogged filter, a cut line under the mulch, an emitter that stopped. The first you know is a plant dying. A short check a few times a year prevents that.

Leer en español

The parts to know

Water passes through a filter, then a pressure regulator, then the drip tubing with emitters along it. The filter catches grit before it reaches the emitters. The end of each line has a cap or a flush valve.

The seasonal checklist

  1. Clean the filter: unscrew the housing, rinse the screen and refit it.

  2. Flush the lines: open the end caps, run the zone until the water is clear, then close them.

  3. Walk the bed while the zone runs and look for dry soil at emitters and wet patches from cuts.

  4. Repair cuts with a barbed coupling and replace clogged emitters.

  5. Check the run time suits the season, and re-cover the tubing with mulch.

Do this in spring, in midsummer and after any planting or mulching work in the bed.

Common problems

The whole zone is dry: a clogged filter, a closed valve or a failed valve.

The end of the line is dry: too many emitters for the line, low pressure, or a kink.

One wet patch: a cut line or a popped emitter. Trowels, edgers and rodents are the usual causes.

White crust on emitters: mineral scale from hard water; replace those emitters.

Drip and your watering days

Many Texas water companies give drip more days or hours than sprinklers. But each sets its own rule. In San Antonio, see the SAWS watering rules. Drip runs longer than spray, often 60 minutes or more, because it puts water down slowly.

Drip maintenance questions

How often should I clean a drip irrigation filter?

About twice a season, and after any repair on the line.

How do I know if my drip system is working?

Run the zone and check the soil at several emitters. It should be damp at each one.

How do I fix a cut drip line?

Cut out the damaged piece and join the ends with a barbed coupling.

Why are my drip emitters clogged?

Grit that got past the filter, or mineral scale from hard water.

Start here: All sprinkler guides.

Also useful: Hose-end sprinklers and watering rules. Sprinkler system inspection checklist. How to turn off a sprinkler system.

Need help? Sprinkler repair in San Antonio.

Need a hand?

SISCO repairs drip zones across Greater San Antonio, Boerne and New Braunfels. Reach out to the irrigation experts at SISCO Irrigation at 210-697-9086 or see smart controllers and drip.

In Cordillera Ranch? The winter visit there is $275. See our winter offer.